Produkten har blivit tillagd i varukorgen
Moms visas:

RYO Trig Xpander v1.1 DIY KIT

375 kr
Finns i lager
Finns ej i lagret
Finns ej i lagret
Bevaka produkt

Ange din e-postadress nedan så meddelar vi dig när produkten finns i lager!

Trig Xpander (for VC Sequencer) DIY Kit
Introducing the first official channel expander module for the VC Sequencer, the Trig Xpander.
This will give your VC Sequencer 8 individual outputs for each step outputting either a trigger or a gate, selectable with a jumper on the pcb, and a 9th output that gives you a trigger for each step progression. Also on board is a trimmer for setting the trigger length to your liking (ca 1-20 ms). Usually you wan't to set this as low as possible to reach higher rates. Different trig lengths can give a different sound from pinging filters or striking lowpassgates. Some vintage gear also require longer trigs. The gates are high for the full duration of each step.
The outputs are diode isolated, this allows for passive mixing of the outputs using a passive multiple/stackcable/IV cable, or a switched multiple/OR combiner such as the Doepfer A-182 or Low-Gain Short Bus.
The kit comes supplied with two PCBs (one with a v-cut that you break into two), front panel (PCB material), component kit, power and expansion cables and mounting screws.
Solder and tools are not supplied.
Basic specifications
• Width: 4hp
• Depth: 45 mm
• Power: +12 mA / -0 mA

Trig Xpander
Lägg i önskelista

RYO-Trig Xpander DIY kit




tumblr site counter