The product has been added to your cart
Show VAT:

RYO Trig Xpander v1.1 DIY KIT

375 kr
Not available
Not available
Product reminder

Enter your e-mail address below and we will notify you when the product is available!

Product Description:
Trig Xpander (for VC Sequencer) DIY Kit
Introducing the first official channel expander module for the VC Sequencer, the Trig Xpander.
This will give your VC Sequencer 8 individual outputs for each step outputting either a trigger or a gate, selectable with a jumper on the pcb, and a 9th output that gives you a trigger for each step progression. Also on board is a trimmer for setting the trigger length to your liking (ca 1-20 ms). Usually you wan't to set this as low as possible to reach higher rates. Different trig lengths can give a different sound from pinging filters or striking lowpassgates. Some vintage gear also require longer trigs. The gates are high for the full duration of each step.
The outputs are diode isolated, this allows for passive mixing of the outputs using a passive multiple/stackcable/IV cable, or a switched multiple/OR combiner such as the Doepfer A-182 or Low-Gain Short Bus.
The kit comes supplied with two PCBs (one with a v-cut that you break into two), front panel (PCB material), component kit, power and expansion cables and mounting screws.
Solder and tools are not supplied.
Basic specifications
• Width: 4hp
• Depth: 45 mm
• Power: +12 mA / -0 mA

Trig Xpander
Add to Wish List

Item ID:
RYO-Trig Xpander DIY kit




tumblr site counter