Produkten har blivit tillagd i varukorgen
Moms visas:

Doepfer A-110-2

1 250 kr
Finns i lager
Finns ej i lagret
.
Finns ej i lagret
Bevaka produkt

Ange din e-postadress nedan så meddelar vi dig när produkten finns i lager!

Produktbeskrivning:
Module A-110-2 is a low-cost voltage-controlled oscillator. It's a slightly reduced version of the standard VCO A-110-1. Compared to the A-110-1 the A-110-2 has no sine output and the (expensive) octave rotary switch is replaced by a 3-position toggle switch. In return the A-110-2 is equipped with an additional linear FM input and a soft sync input. A jumper is used to select the range of the tune control between about 1/2 octave and about 4 octaves. The width of the module is only 8 HP compared to the 10 HP of the A-110-1.
All other features are essentialy the same as for the A-110-1.
Explanation of the jumpers and trimming potentiometers: JP2: CV connection to A-100 bus JP3: range of Tune control (installed = about 4 octaves, not installed = about 1/2 octave) JP4: AC/DC coupling of the linear FM input (installed = DC coupling, not installed = AC coupling) P5: 1V/Oct scale P6: frequency offset P7: high-end trim P8: adjustment +1 Oct. range switch P9: adjustment -1 Oct. range switch P10: temperature VCO heater
Technical remarks:
The core of the A-110-2 is - like the A-110-1 - a sawtooth oscillator (in contrast to the A-111-1, which is based on a triangle oscillator). The other waveforms are derived from the sawtooth by waveform converters. As the sawtooth reset (i.e. the back-to-zero slope) is not infinitely fast but takes a little bit of time the triangle is not perfect ! At the bottom of the waveform it has a small glitch or notch that is caused by the sawtooth reset and cannot be eliminated by the waveform converter. If a perfect triangle is required the A-111-1 is recommended.



Artikelnummer:
Doepfer A-110-2

Produkter

Handla

Information


tumblr site counter