Produkten har blivit tillagd i varukorgen
Moms visas:

Doepfer A-160-2

925 kr
Finns i lager
Finns ej i lagret
.
Finns ej i lagret
Bevaka produkt

Ange din e-postadress nedan så meddelar vi dig när produkten finns i lager!

Produktbeskrivning:
Module A-160-2 is an enhanced version of the standard clock divider A-160. The module is a frequency divider for clock/trigger/gate signals, designed to be a source of lower frequencies, particularly for rhythm uses. The Clock input will take any digital signal from, eg., an LFO, MIDI sync, or the gate from a MIDI-CV interface. At the outputs, you have access to three sets of seven different sub-divided clock signals, from half the clock frequency down to 1/128. The low/high levels of the output signals are 0V and about +10V.
The A-160-2 also has a reset input. Whenever a reset signal is sensed, all outputs are set to certain levels which depend upon the selected mode.

These are the most important features of the module:

Three different sets of dividing factors, selected by a three-position switch at the front panel:

• power of two: 2, 4, 8, 16, 32, 64, 128
• prime numbers: 2, 3, 5, 7, 11, 13, 17
• integer: 2, 3, 4, 5, 6, 7, 8

Two output modes, selected by a two-position switch at the front panel:

• Gate mode: outputs act like the outputs of typical binary dividers
• Trigger mode: in this mode the outputs are AND-wired with the clock signal (i.e. the clock pulsewidth affects the pulsewidth of the outputs)

Clock edge type selected by a jumper on the pc board:
• positive: the rising edge of the clock signal triggers the state change of the outputs
• negative: the falling edge of the clock signal triggers the state change of the outputs

Reset behaviour by two jumpers on the pc board:
• level triggered: the level at the Reset input triggers the Reset
• edge triggered: the edge of the signal at the Reset input triggers the Reset
• positive: a high level (> 2.5V) or the rising edge at the Reset input triggers the Reset
• negative: a low level (< 1 V) or the falling edge at the Reset input triggers the Reset

Output polarity selected by a jumper on the pc board:
• positive: non-inverted outputs
• negative: all seven outputs are inverted

• 4 HP
• Draw 50 mAh



Artikelnummer:
Doepfer-A-160-2

Produkter

Handla

Information


tumblr site counter