0HP OR Gate
The 0HP OR Gate can be used to combine different signals, usually gate or clock signals. The output will give a high voltage whenever a high voltage is present at either of the inputs. This can be useful for combining multiple different gate sources together to trigger the same module, such as using a gate sequencer and a burst generator on a drum module to get drum fills. This module can also process fluctuating voltages, outputting the maximum of the two inputs (the highest of the input voltages above 0). The built in trigger converter outputs a spike whenever the main output transitions from low to high.
Since the modules are passive, some signal loss and distortion should be expected. The user is expected to keep cables away from the top of the circuit board. While in 99.9% of cases an accidental short circuit is not an issue, Mystic Circuits, Eli Pechman or any of our retailers assume NO RESPONSIBILITY for modules that are accidentally damaged by doing so. This expectation follows same logic as not plugging an output into another output or touching your cables to the panels, which are common safety practices expected to be followed by the end user.